1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for
1 min or more
.
3. Remove the front scuff plate inner. (See
FRONT SCUFF PLATE REMOVAL/INSTALLATION
.)
4. Remove the rear scuff plate inner. (See
REAR SCUFF PLATE REMOVAL/INSTALLATION
.)
5. Remove the cover by pulling it in the direction of the arrow.
Fig. 2: Identifying Front Seat Belt, Bolts & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
6. Remove the bolt A.
7. Remove the B-pillar lower trim. (See
B-PILLAR LOWER TRIM REMOVAL/INSTALLATION
.)
8. Remove the adjuster anchor cover.
9. Remove the bolt B and bolt C, then remove the front seat belt.
10. Using a screwdriver, pry out the pre-tensioner seat belt connector's stopper plate.
11. Disconnect the pre-tensioner seat belt connector.
12. Install in the reverse order of removal.
13. Turn the ignition switch to the ON position.
14. Verify that the air bag system warning light illuminates for
approx. 6 s
and goes out.
z
If the air bag system warning light does not operate, refer to the on-board diagnostic system (air
bag system) and perform inspection of the system. (See
FLOWCHART
.)
z
The ELR (emergency locking retractor) has a spring that will unwind
if the retractor cover is removed. The spring cannot be rewound by
hand. If this occurs, the ELR will not work properly. Therefore, do not
disassemble the retractor.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Seat Belt - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:19:40 AM
Page 2
© 2005 Mitchell Repair Information Company, LLC.
