DTC P1260 [MZI-3.7]
DTC P1260 (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DIAGNOSTIC PROCEDURE
DTC P1260 (MZI-3.7) DIAGNOSTIC PROCEDURE
7
z
Perform "AFTER REPAIR
PROCEDURE". (See
AFTER
REPAIR PROCEDURE [MZI-
3.7]
.)
z
Are any DTC present?
Yes
Go to the applicable DTC inspection. (See
DTC
TABLE [MZI-3.7]
.)
No
Troubleshooting completed.
DTC P1260
Theft detected, vehicle immobilized
DETECTION
CONDITION
Indicates that the RATS determined a theft condition existed and the engine is
disabled. This DTC is a good indicator to check the PATS for DTCs.
POSSIBLE CAUSE
z
Previous theft condition
z
Anti-theft system failure Theft indicator flashing rapidly or on solid when the
ignition switch is in the ON position.
z
Check the anti-theft system for DTCs.
STEP
INSPECTION
ACTION
1
VERIFY FREEZE FRAME DATA
HAS BEEN RECORDED
z
Has FREEZE FRAME DATA been
recorded?
Yes Go to the next step.
No
Record FREEZE FRAME DATA on the repair
order, then go to the next step.
2
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
z
Verify related Service Bulletins
and/or on-line repair information
availability.
z
Is any related Service Bulletins
available?
Yes
Perform repair or diagnosis according to the
available Service Bulletins.
z
If the vehicle is not repaired, go to the next
step.
No
Go to the next step.
INSPECT ALL OTHER PATS DTCs
z
Repair all other PATS DTCs before
P1260.
(See
IMMOBILIZER SYSTEM
COMPONENT
REPLACEMENT/KEY
ADDITION AND CLEARING
Yes Go to the next step.
(See
IMMOBILIZER SYSTEM
COMPONENT REPLACEMENT/KEY
2008 Mazda CX-9 Grand Touring
2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:08:40 AM
Page 319
© 2005 Mitchell Repair Information Company, LLC.
