WITH TWO PROGRAMMED CARD KEYS
1. Bring the programmed card keys (2) and a unprogrammed card key into the vehicle.
2. Close all doors.
3. Insert the supplementary key into the ignition key cylinder.
4. Turn the ignition switch to the ON position.
5. Press the UNLOCK button on card key 1.
6. Press the UNLOCK button on card key 2.
7. From the ignition switch in the ON position, switch the ignition switch in the order indicated below.
{
ACC --> ON --> ACC --> ON --> ACC --> ON
8. Open the driver-side front door, press the door switch
twice
, and then close the door.
9. Press the UNLOCK button on the unprogrammed card key
twice.
10. If programming more card keys, remove the supplementary key once, and then repeat the procedure from
Step 2.
USING M-MDS
servicing area during card key programming.
NOTE:
z
Use the M-MDS and start programming if the condition corresponds to the
following:
{
One or No Programmed Card Keys
{
Keyless control module is replaced
z
If six card keys are already programmed, the programming mode does not
activate. If programming is needed, use the M-MDS to erase the
unnecessary card key programming.
NOTE:
z
Complete the procedures up to Step 7 within
30 s after
the
supplementary key is inserted.
NOTE:
z
After Step 3 is completed and the card key programming mode is
activated, the door lock actuator operates to lock, and then operates
to unlock.
z
If the door lock actuator does not operate, repeat the procedure from
Step 2.
NOTE:
z
After Step 8 is completed and the card key is programmed, the door
lock actuator operates to lock, and then operates to unlock.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:47:58 AM
Page 38
© 2005 Mitchell Repair Information Company, LLC.
