Inner diameter: 53 mm {2.1 in} or more
Inner depth: 7.5 mm {0.30 in} or more
Fig. 46: Pressing Dust Seal (Axle Side) With SST
Courtesy of MAZDA MOTORS CORP.
REAR DRIVE SHAFT PRE-INSPECTION
1. Inspect each connecting part for looseness.
z
Tighten or replace parts if necessary.
2. Inspect the dust boot on the drive shaft for cracks, damage, leaking grease, and looseness in the boot
band.
3. Inspect the drive shaft for bends, cracks, and wear in the joints or splines.
z
Repair or replace the drive shaft or boot band if necessary.
Fig. 47: Locating Dust Boot
Courtesy of MAZDA MOTORS CORP.
REAR DRIVE SHAFT REMOVAL/INSTALLATION
CAUTION:
z
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:50:58 AM
Page 30
© 2005 Mitchell Repair Information Company, LLC.
