3. Remove the tape.
TRIPOD JOINT, SNAP RING ASSEMBLY NOTE
1. Align the marks and install the tripod joint using a bar and a hammer.
2. Install the new snap ring using snap-ring pliers.
OUTER RING ASSEMBLY NOTE
1. Fill the outer ring and boot (transaxle side) with the specified grease.
Grease amount 240-260 g {8.48-9.17 oz}
2. Install the roller cassettes.
3. Align the marks, and install the outer ring on to the shaft.
4. Install a new clip.
5. Install the boot.
6. Set the drive shaft to the standard length.
Front drive shaft standard length
LH: 658.7-668.7 mm {25.92-26.30 in}
RH: 630.7-640.7 mm {24.82-25.20 in}
CAUTION:
z
Be sure the snap ring engages correctly in the groove of the
shaft.
Fig. 19: Identifying Mark Location
Courtesy of MAZDA MOTORS CORP.
CAUTION:
z
Do not touch grease with your hand. Apply it from the tube to
prevent foreign matter from entering the boot.
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:50:57 AM
Page 12
© 2005 Mitchell Repair Information Company, LLC.
