z
When using the PDS (Pocket PC)
1. Select "All Tests and Calibrations".
4. Then, select items from the screen menu in the following order.
z
Select "ABS Service Bleed"
5. Perform the air bleeding according to the directions on the screen.
Fig. 13: Connecting M-MDS To DLC-2
Courtesy of MAZDA MOTORS CORP.
DSC/RSC SENSOR INITIALIZATION PROCEDURE
1. Inspect the wheel alignment and inflation pressure.
z
If there is any malfunction, adjust the applicable part.
2. Park the vehicle on level ground.
3. Turn the ignition switch off.
4. Connect the M-MDS to the DLC-2.
5. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
z
When using the IDS (laptop PC)
WARNING:
z
Unless the initialization procedure of the combined sensor is
completed, the DSC/RSC will not operate, causing an unexpected
accident. Therefore, always perform the initialization procedure to
ensure DSC/RSC operation if the combined sensor and DSC/RSC
HU/CM have been removed or replaced.
2008 Mazda CX-9 Grand Touring
2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:40:24 AM
Page 12
© 2005 Mitchell Repair Information Company, LLC.
