Fig. 18: Identifying Bolt, Connector & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
5. Install in the reverse order of removal.
6. Turn the ignition switch to the ON position.
7. Verify that the air bag system warning light illuminates for
approx. 6 s
and goes out.
z
If the air bag system warning light does not operate normally, refer to the on-board diagnostic
system (air bag system) and perform inspection of the system. (See
FLOWCHART
.
SAS CONTROL MODULE REMOVAL/INSTALLATION
1. Perform SAS control module configuration when replacing it. (See
SAS CONTROL MODULE
CONFIGURATION
.)
2. Turn the ignition switch to the LOCK position.
3. Disconnect the negative battery cable and wait for
1 min or more
.
4. Remove the following parts:
WARNING:
z
Handling the SAS control module improperly can accidentally
deploy the air bag modules and pre-tensioner seat belt, which may
seriously injure you. Read the service warnings and cautions before
handling the air bag module. (See AIR BAG SYSTEM SERVICE
WARNINGS.) (See AIR BAG SYSTEM SERVICE CAUTIONS.)
z
Connecting the SAS control module with the SAS control module
not securely fixed to the vehicle is dangerous. When the ignition
switch is turned to the ON position, the SAS control module could
tilt causing the SAS control module to detect that the vehicle is in a
rollover condition, which may accidentally operate (deploy) the
curtain air bag module and pre-tensioner seat belt. Therefore, before
turning the ignition switch to the ON position with the connector
connected, securely fix the SAS control module to the vehicle.
CAUTION:
z
Handling the SAS control module improperly can accidentally deploy
the air bag modules and pre-tensioner seat belt, which may seriously
injure you. If configuration is not completed before removing the SAS
control module, DTC B2477 will be displayed.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:16:38 AM
Page 16
© 2005 Mitchell Repair Information Company, LLC.
