7. Input the "IN-CODE" that corresponds to the "OUT-CODE" displayed in the M-MDS screen.
8. Select "CARD KEY CLEARING" from the M-MDS screen menu.
STEERING LOCK UNIT ID CODE REGISTRATION [ADVANCED KEYLESS
SYSTEM]
1. Bring the programmed card key into the vehicle.
2. Fully lower the driver-side door glass.
3. Connect the M-MDS to the DLC-2.
4. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.
5. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
CAUTION:
z
Do not place the following devices in the vehicle while programming,
otherwise programming cannot be performed.
{
M-MDS
{
Personal computer
{
Device that can send/receive radio waves
NOTE:
z
The steering lock unit and steering lock component are a single unit.
Therefore, replace the steering lock component when replacing steering
lock unit. (See STEERING WHEEL AND COLUMN
REMOVAL/INSTALLATION .)
z
For this procedure, a programmed card key is necessary. If there is no
programmed card key, perform the steering lock unit programming after
the card key programming.
CAUTION:
z
Protect the cable and body contact area with a clean rag,
otherwise they could be damaged.
Fig. 62: Identifying DLC-2 Location
Courtesy of MAZDA MOTORS CORP.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:47:58 AM
Page 41
© 2005 Mitchell Repair Information Company, LLC.
