1. Level the vehicle.
2. Complete the "BEFORE SERVICE PRECAUTION". (See
BEFORE SERVICE PRECAUTION [MZI-
3.7]
.)
3. Disconnect the negative battery cable. (See
BATTERY REMOVAL/INSTALLATION [MZI-3.7]
.)
4. Remove the engine cover. (See
ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7]
.)
5. Remove the fuel line schrader valve cap.
6. Connect a long hose to the disconnected schrader valve cap and drain the fuel into a container used for
collecting gasoline.
7. Start the fuel pump using the following procedure.
Fig. 26: Identifying Schrader Valve Cap & Fuel Distributor
Courtesy of MAZDA MOTORS CORP.
removal/installation, always complete the "Fuel Leak Inspection
After Fuel Pump Unit Installation".
z
A person charged with static electricity could cause a fire or
explosion, resulting in death or serious injury. Before draining fuel,
make sure to discharge static electricity by touching the vehicle
body.
CAUTION:
z
Because the fuel tank is constructed such that the fuel level is higher
than the installation surface of the fuel pump, fuel leakage could
occur. If the fuel gauge indicates a fuel level of 3/4 or more, perform
the following Steps 3 - 8 to drain 10-15 L {2.7-3.9 US gal, 2.2-3.2 Imp
gal} of fuel.
z
Disconnecting/connecting the quick release connector without
cleaning it may possibly cause damage to the fuel pipe and quick
release connector. Always clean the quick release connector joint
area before disconnecting/connecting using a cloth or soft brush,
and make sure that it is free of foreign material.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Fuel System (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:04:45 AM
Page 22
© 2005 Mitchell Repair Information Company, LLC.
