1. Disconnect the negative battery cable. (See
BATTERY REMOVAL/INSTALLATION [MZI-3.7]
.)
2. Remove in the order indicated in the table.
Fig. 13: Identifying Purge Solenoid Valve & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
3. Install in the reverse order of removal.
PURGE SOLENOID VALVE INSPECTION [MZI-3.7]
AIRFLOW INSPECTION
1. Disconnect the negative battery cable. (See
BATTERY REMOVAL/INSTALLATION [MZI-3.7]
.)
2. Disconnect the quick release connector from the purge solenoid valve. (See
QUICK RELEASE
CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [MZI-3.7]
.)
3. Remove the purge solenoid valve. (See
PURGE SOLENOID VALVE REMOVAL/INSTALLATION
[MZI-3.7]
.)
4. Verify that the airflow is as indicated in the table.
z
If as specified in the table, perform the "Circuit Open/Short Inspection".
z
If not as specified in the table, inspect the purge solenoid valve.
CONTINUITY CHART
Measured condition
Continuity between A-B
When voltage is not applied between terminals A and B
No airflow
When voltage is applied between terminals A and B
Airflow detected
2008 Mazda CX-9 Grand Touring
2008 ENGINE PERFORMANCE Emission System (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:04:04 AM
Page 11
© 2005 Mitchell Repair Information Company, LLC.