10. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Exit (From
This Menu)" to finish the M-MDS procedure.
11. After Step 10, wait 5 s or more and then turn the ignition switch to the LOCK position.
12. Disconnect the M-MDS from the DLC-2.
13. Using key 1, turn the ignition switch to the ON position.
14. After verifying that the security light illuminates for 3 s or more, turn the ignition switch to the LOCK
position, remove key 1, and go to the next step.
15. Using key 2, turn the ignition switch to the ON position.
16. Verify that the security light illuminates for approx. 3 s and then turns off.
17. After verifying that the security light turns off, turn the ignition switch to the LOCK position and remove
key 2.
18. If programming one more keys, repeat Steps 15 to 17 with a key to be programmed as key 3. Steps 15 to
17 must be performed within 1 min for each key. If the vehicle is left with the ignition switch in the ON
position for 1 min or more, additional key programming according to Steps 15 to 17 is disabled. If this
occurs, refer to "
NO.1 ADDITIONAL KEY REGISTRATION PROCEDURE (USING TWO
VALID KEYS)
" to register any additional keys.
19. Verify that the all keys can start the engine for
5 s or more
after the procedure.
NO.6 RESETTING PROCEDURE FOR THE IMMOBILIZER SYSTEM WHEN REPLACING THE
PCM
Procedure
Fig. 103: Resetting Procedure For - Immobilizer System When Replacing PCM
NOTE:
z
At this time, do not select the other parts from the M-MDS menu.
NOTE:
z
Although the security light remains illuminated and DTC 21 is
displayed after approx. 1 min, this does not indicate an improper
procedure. Continue to perform the procedure as indicated.
CAUTION:
z
Before starting Step 1, complete the procedure for the PCM
replacement. (See PCM REMOVAL/INSTALLATION [MZI-3.7] .)
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:47:59 AM
Page 91
© 2005 Mitchell Repair Information Company, LLC.
