DTC C1194, C1198, C1210, C1214, C1242, C1246, C1250, C1254, C1404,
C1410, C1957, C1958 [DSC/RSC]
DTC C1194, C1198, C1210, C1214, C1242, C1246, C1250, C1254, C1404, C1410, C1957, C1958
[DSC/RSC] DETECTION CONDITION AND POSSIBLE CAUSE
{
RR ABS wheel-speed sensor: J-B
{
LR ABS wheel-speed sensor: F-A
{
LR ABS wheel-speed sensor: I-B
z
Is there continuity?
3
INSPECT ABS WHEEL-SPEED SENSOR
FOR MALFUNCTION
z
Turn the ignition switch off.
z
Disconnect the ABS wheel-speed sensor
connector which may have a malfunction.
z
Turn the ignition switch to the ON position,
(engine off)
z
Measure the power supply voltage between
the ABS wheel-speed sensor connector
terminal A (vehicle wiring harness-side) and
body ground on the ABS wheel-speed
sensor which may have a malfunction.
z
Is the power supply voltage of the ABS
wheel-speed sensor which may have a
malfunction more than 10 V?
Yes
Replace the ABS wheel-speed sensor, then
go to the next step.
(See
FRONT ABS WHEEL-SPEED
SENSOR
REMOVAL/INSTALLATION
.)
(See
REAR ABS WHEEL-SPEED
SENSOR
REMOVAL/INSTALLATION [2WD]
.)
(See
REAR ABS WHEEL-SPEED
SENSOR
REMOVAL/INSTALLATION [AWD]
.)
No
Go to the next step.
4
VERIFY THAT THE SAME DTC IS NOT
PRESENT
z
Clear the DTCs from the memory.
(See
ON-BOARD DIAGNOSTIC
[DSC/RSC]
.)
z
Are the same DTCs present?
Yes
Repeat the inspection from Step 1.
If the malfunction recurs, replace the
DSC/RSC HU/CM, then go to the next
step.
(See
DSC/RSC HU/CM
REMOVAL/INSTALLATION
.)
No
Go to the next step.
5
VERIFY THAT NO OTHER DTCS ARE
PRESENT
z
Are any other DTCs output?
Yes
Go to the applicable DTC inspection.
(See
ON-BOARD DIAGNOSTIC
[DSC/RSC]
.)
No
DTC troubleshooting completed.
DTC C1194
LF outlet solenoid valve system
DTC C1198
LF inlet solenoid valve system
DTC C1210
RF outlet solenoid valve system
DTC C1214
RF inlet solenoid valve system
2008 Mazda CX-9 Grand Touring
2008 BRAKES On-Board Diagnostic (DSC/RSC) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:50:13 AM
Page 25
© 2005 Mitchell Repair Information Company, LLC.
