DTC P1001 [MZI-3.7]
DTC P1001 (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
STEP
INSPECTION
ACTION
1
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
z
Has FREEZE FRAME DATA been
recorded?
Yes Go to the next step.
No
Record FREEZE FRAME DATA on the repair
order, then go to the next step.
2
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
z
Verify related Service Bulletins and/or
on-line repair information availability.
z
Is any related Service Bulletins
available?
Yes
Perform repair or diagnosis according to the
available Service Bulletins.
z
If the vehicle is not repaired, go to the
next step.
No
Go to the next step.
3
DTC P1000: INSPECT FOR OTHER DTCS
z
This test should be used only if DTC
P1000 was received in Continuous
Memory. Ignore any DTC P1000s in
KOEO or KOER.
z
Were any other DTCs received with
P1000?
NOTE:
z
DTC P1000 indicates that all of
the OBD-II monitors have not
yet been successfully tested to
clear DTC P1000.
Yes
Repair other DTCs. Go to the applicable DTC
Troubleshooting.
No
Go to the next step.
4
REQUEST TO CLEAR DTC P1000
z
Has the customer requested DTC P1000
be cleared from the PCM memory?
Yes Perform the Drive Mode.
(See
OBD-II DRIVE MODE [MZI-3.7]
.)
No
Inform customer that if the law in the state
requires additional driving in order to clear
DTC P1000 from the PCM memory, it must be
performed before an inspection maintenance
test.
5
VERIFY AFTER REPAIR PROCEDURE
z
Perform the "AFTER REPAIR
PROCEDURE". (See
AFTER
REPAIR PROCEDURE [MZI-3.7]
.)
z
Are any DTC present?
Yes Go to the applicable DTC inspection. (See
DTC TABLE [MZI-3.7]
.)
No
Troubleshooting completed.
2008 Mazda CX-9 Grand Touring
2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:08:40 AM
Page 310
© 2005 Mitchell Repair Information Company, LLC.
