Fig. 156: Measuring Starting And Rotating Torque Of Counter Drive Gear
Courtesy of MAZDA MOTORS CORP.
COUNTER DRIVE GEAR STARTING AND ROTATING TORQUE
z
Adjust the starting and rotating torque by tightening the nut.
z
If the starting and rotating torque does not fall within the specification, loosen the nut and retighten
the nut to adjust torque.
9. Using a flathead screwdriver and hammer, crimp down the washer.
Fig. 157: Crimping Down Washer
Courtesy of MAZDA MOTORS CORP.
10. Using a flathead screwdriver, install the hole snap ring to the counter drive gear.
11. Install the rear planetary ring gear flange to the rear planetary ring gear.
N.m {kgf.cm, in.lbf}
Bearing
Starting torque
Rotating torque
New 0.40 - 0.50 {4.08 - 5.09, 3.55 - 4.41} 0.40 - 0.48 {4.08 - 4.89, 3.55 - 4.24}
Reused 0.20 - 0.25 {2.04 - 2.54, 1.77 - 2.20} 0.20 - 0.24 {2.04 - 2.44, 1.77 - 2.11}
2008 Mazda CX-9 Grand Touring
2005-08 TRANSMISSION Automatic Transaxle Overhaul (AW6A-EL) - CX-7, CX-9 & Mazda 6
Microsoft
Sunday, November 15, 2009 10:28:16 AM
Page 81
© 2005 Mitchell Repair Information Company, LLC.
