Courtesy of MAZDA MOTORS CORP.
10. Install the SSTs (reflector and plum-bob) to the SST (tripod) and adjust the height of the reflector at its
center to
534 mm ± 8 mm {21.0 in ± 0.3 in}.
Fig. 31: Identifying Height Of Reflector
Courtesy of MAZDA MOTORS CORP.
11. Verify visually that the reflecting surface of the reflector is facing the BSM control module, and position
the SST (tripod) so that the SST (plum-bob) is positioned over the marked position.
Fig. 32: Identifying Center Plumbob Over Floor Mark
Courtesy of MAZDA MOTORS CORP.
12. Perform the BSM radar test according to the screen instructions using the IDS.
NOTE:
z
The BSM installation position is indicated in the figure.
NOTE:
z
Use the IDS (laptop PC) because the PDS (Pocket PC) does not
support the blind spot monitoring (BSM) radar test.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Instrumentation/Driver Info - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:42:27 AM
Page 41
© 2005 Mitchell Repair Information Company, LLC.
