5. Turn the ignition switch to the ON position.
6. Verify that the air bag system warning light illuminates for
approx. 6 s
and goes out.
z
If the air bag system warning light does not operate normally, refer to the on-board diagnostic
system (air bag system) and perform inspection of the system. (See
FLOWCHART
.)
CONNECTOR A REMOVAL NOTE
1. Using a flathead screwdriver, pry out the connector stopper plate.
2. Disconnect the connector.
Fig. 10: Prying Out Connector Stopper Plate Using Screwdriver
Courtesy of MAZDA MOTORS CORP.
PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for
1 min or more
.
3. Remove the following parts:
1. Decoration panel (See
DECORATION PANEL REMOVAL/INSTALLATION
.)
2. Front console box mat (See
FRONT CONSOLE BOX MAT REMOVAL/INSTALLATION
.)
3. Indicator panel (See
INDICATOR PANEL REMOVAL/INSTALLATION
.)
WARNING:
z
Handling the air bag module improperly can accidentally deploy the
air bag module, which may seriously injure you. Read the air bag
system service warnings and cautions before handling the air bag
module. (See AIR BAG SYSTEM SERVICE WARNINGS.) (See AIR
BAG SYSTEM SERVICE CAUTIONS.)
z
Due to the adoption of 2-step deployment control in the passenger-
side air bag module, depending on the impact force, it is possible
that inflator No.2 might not deploy. In such cases, before disposing
of the air bag module, make sure to follow the inflator deployment
procedures and verify complete deployment of inflators No.1 and 2.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:16:38 AM
Page 9
© 2005 Mitchell Repair Information Company, LLC.
