12. Apply silicone sealant to the oil pressure switch threads as shown in the figure.
13. Install the oil pressure switch.
Tightening torque
10.7-24.5 N.m {1.1-2.4 kgf.m, 7.9-18.0 ft.lbf}
14. Install the fan control module No.2. (Dual fan control module) (See
COOLING FAN COMPONENT
REMOVAL/INSTALLATION [MZI-3.7]
.)
15. Connect the negative battery cable.
Fig. 5: Applying Silicone Sealant To Oil Pressure Switch Threads
Courtesy of MAZDA MOTORS CORP.
16. Start the engine and confirm that there is no oil leakage.
z
If there is oil leakage, repair or replace the applicable part.
17. Install the engine cover.
OIL COOLER REMOVAL/INSTALLATION [MZI-3.7]
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See
ENGINE COOLANT REPLACEMENT [MZI-3.7]
.)
3. Remove the air cleaner and fresh air duct component. (See
INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [MZI-3.7]
.)
WARNING:
z
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine oil have cooled.
z
A vehicle that is lifted but not securely supported on safety stands is
dangerous. It can slip or fall, causing death or serious injury. Never
work around or under a lifted vehicle if it is not securely supported
on safety stands.
z
Continuous exposure to USED engine oil has caused skin cancer in
laboratory mice. Protect your skin by washing with soap and water
immediately after working with engine oil.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Lubrication (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:01:14 AM
Page 6
© 2005 Mitchell Repair Information Company, LLC.
