and then remove key 2.
21. If programming one more keys, repeat Steps 18 to 20 with a key to be programmed as key 3. If the
vehicle is left with the ignition switch in the ON position for 1 min or more, additional key programming
according to Steps 18 to 20 is disabled. If this occurs, refer to the "
M-MDS CONNECTING
PROCEDURE
" to program any additional keys. (See
M-MDS MENU
.)
22. Start the engine with key 1.
23. Verify that the security light and keyless warning light operate as follows:
z
From the point when the ignition switch is turned to the ON position, the security light illuminates
for approx. 3 s
, and goes out.
z
The keyless warning light illuminates when the ignition switch is turned to the ON position, and the
light goes out after
approx. 1 s
, and then displays the number of the programmed keys.
Fig. 97: Identifying Blinking Pattern - Keyless Warning Light
Courtesy of MAZDA MOTORS CORP.
24. After verifying that the keyless warning light goes out, turn the ignition switch to the LOCK position
using key 1, and then remove the key.
25. Repeat Steps 22 to 24 using key 2 instead of key 1.
26. Start the engine using the card key.
NOTE:
z
If three or more keys have already been programmed, perform Steps
22 to 24.
CAUTION:
z
Remove any key from the key cylinder.
z
Close all doors.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:47:59 AM
Page 79
© 2005 Mitchell Repair Information Company, LLC.
