Fig. 4: Tapping Locknut
Courtesy of MAZDA MOTORS CORP.
FRONT DRIVE SHAFT REMOVAL NOTE
1. Install a spare nut onto the drive shaft so that the nut is flush with the end of the drive shaft.
2. Tap the nut with a copper hammer to loosen the drive shaft from the front wheel hub.
3. Separate the drive shaft from the wheel hub.
4. Separate the left side drive shaft from the transaxle by prying with a bar inserted between the outer ring
and the transaxle, as shown in the figure.
CAUTION:
z
The sharp edges of the drive shaft can slice or puncture the oil
seal. Be careful when removing the drive shaft from the
transaxle.
Fig. 5: Tapping Drive Shaft
Courtesy of MAZDA MOTORS CORP.
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:50:57 AM
Page 4
© 2005 Mitchell Repair Information Company, LLC.
