10. Perform the security access according to the directions on the M-MDS screen. (See
SECURITY
ACCESS PROCEDURE
.)
11. Turn the ignition switch to the LOCK position and remove key 2.
12. If additional keys need to be programmed, repeat Steps 6-10, and replace key 3 in Step 10 with the key to
be programmed.
13. After verifying that the PATS function menu is displayed again on the M-MDS screen, select the "Exit
(From This Menu)" to finish the M-MDS procedure.
14. After Step 10, wait
5 s or more
, and then turn the ignition switch to the LOCK position.
15. Verify that the all keys can start the engine for 5 s or more after the procedure.
NO.3 KEY REPLACEMENT PROCEDURE (CLEARING PREVIOUSLY PROGRAMMED KEY ID
NUMBERS, KEY RE-PROGRAM)
Condition
z
Prepare two or more keys to be programmed after the key ID number is cleared.
Procedure
Fig. 89: Key Replacement Procedure
Courtesy of MAZDA MOTORS CORP.
1. Prepare two or more keys to be programmed after the key ID number is cleared.
2. Connect the M-MDS to the DLC-2. (See
M-MDS MENU
.)
3. Using key 1, turn the ignition switch to the ON position.
NOTE:
z
After selecting the above menu, "This operation has been
successful" is displayed. At this point, the key that turned the
ignition switch to the ON position is completely programmed.
NOTE:
z
Although the security light starts flashing and DTC 15 or DTC 23 is
displayed after approx. 1 min, this does not indicate an improper
procedure. Continue to perform the procedure as indicated.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:47:59 AM
Page 65
© 2005 Mitchell Repair Information Company, LLC.
