DTC B110E, B110F, B2856, B2886, B2887
DTC B110E, B110F, B2856, B2886, B2887 DETECTION CONDITION AND POSSIBLE CAUSE
following:
{
Short to ground
{
Short to power supply
{
Open circuit
z
Is the wiring harness normal?
No
Replace the air bag wiring harness.
3
INSPECT SAS CONTROL MODULE
z
Connect the SAS control module connector.
z
Connect the driver and passenger-side pre-
tensioner seat belt connectors.
z
Connect the passenger-side side air bag sensor
No.2 connector.
z
Connect the driver and passenger-side curtain
air bag module connectors.
z
Connect the driver and passenger-side front seat
connectors.
z
Connect the passenger-side air bag module
connector.
z
Connect the clock spring connector.
z
Connect the negative battery cable.
z
Turn the ignition switch to the ON position.
z
Are DTCs B105F, B110D, B1146 and/or B1147
indicated?
Yes
Replace the SAS control module. (See
SAS CONTROL MODULE
REMOVAL/INSTALLATION
.)
No
DTC troubleshooting completed.
DTC
B110E Driver-side side air bag sensor No.2 ID mismatch
B110F Passenger-side side air bag sensor No.2 ID mismatch
B2856 Crash zone sensor ID mismatch
B2886 Passenger-side side air bag sensor No.1 ID mismatch
B2887 Driver-side side air bag sensor No.1 ID mismatch
DETECTION
CONDITION
z
The SAS control module detects an error of impact magnitude set in the sensor,
which occurs due to installation mismatch of the crash zone sensor or side air
bag sensors.
WARNING:
z
Detection conditions are for understanding the DTC outline before
performing an inspection. Performing an inspection according to only the
detection conditions may cause injury due to an operating error, or damage
the system. When performing an inspection, always follow the inspection
procedure.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:47 AM
Page 67
© 2005 Mitchell Repair Information Company, LLC.
