3. Remove the auto light/wiper control module. (See
AUTO LIGHT/WIPER CONTROL MODULE
REMOVAL/INSTALLATION
.)
4. Install in the reverse order of removal.
AUTO LIGHT/WIPER CONTROL MODULE INSPECTION
1. Auto light/wiper control module inspection. (See
AUTO LIGHT/WIPER CONTROL MODULE
INSPECTION
.)
RAIN SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the rearview mirror cover, (See
REARVIEW MIRROR REMOVAL [VEHICLES WITH
AUTO LIGHT/WIPER SYSTEM]
.)
3. Disconnect the rain sensor connector.
4. Slide both tabs located on each side of the rain sensor in the direction of the arrow and remove the rain
sensor.
5. Install in the reverse order of removal.
NOTE:
z
Auto wiper system are integrated with the auto light/wiper control module.
CAUTION:
z
When the ignition switch is turned to the ON position after replacing
the rain sensor with a new one, the windshield condition is verified
and the initial setting is stored. Before installing a rain sensor,
always remove water and dirt from the windshield.
NOTE:
z
Perform the initial setting again in the following cases: (See RAIN SENSOR
REINITIALIZATION SETTING.)
{
The windshield is replaced and the rain sensor is reused.
{
The auto wiper system operates incorrectly.
z
The rain sensor is integrated with the auto light sensor as a single unit.
2008 Mazda CX-9 Grand Touring
2008 ACCESSORIES & BODY, CAB Wiper/Washer System - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:35:20 AM
Page 27
© 2005 Mitchell Repair Information Company, LLC.
