Fig. 39: Removing Rain Sensor
Courtesy of MAZDA MOTORS CORP.
RAIN SENSOR REINITIALIZATION SETTING
WITHOUT USING M-MDS
1. Remove water and dirt from the windshield surface.
2. Turn the ignition switch off.
3. Turn the windshield wiper switch to the AUTO position.
4. Within 10 s after turning the ignition switch to the ON position, turn the windshield wiper switch from
the AUTO to the OFF position for five times and return it to the AUTO position.
CAUTION:
z
If the initialization is performed again with water or dirt on the
windshield, the rain sensor may not operate normally. Before
performing the rain sensor initialization again, remove water and dirt
from the windshield
NOTE:
z
When the ignition switch is turned to the ON position after replacing the
rain sensor with a new one, the windshield condition is verified and the
initial setting is stored.
z
Perform the initial setting again in the following cases:
{
The windshield is replaced and the rain sensor is reused.
{
The auto wiper system operates incorrectly.
2008 Mazda CX-9 Grand Touring
2008 ACCESSORIES & BODY, CAB Wiper/Washer System - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:35:20 AM
Page 28
© 2005 Mitchell Repair Information Company, LLC.
