8. Remove the nuts.
9. Pull the rear finisher outward, then disengage clip A, B, and C from the body.
10. Remove the rear finisher.
11. Remove the request switch. (See
REQUEST SWITCH REMOVAL/INSTALLATION [ADVANCED
KEYLESS SYSTEM]
.)(Vehicles with advanced keyless system)
12. Remove the rear mount camera. (See
REAR MOUNT CAMERA REMOVAL/INSTALLATION
.)
(Vehicles with rear mount camera)
13. Install in the reverse order of removal.
Fig. 13: Identifying Request Switch Connector, Rear Mount Camera Connector & Torque
Specifications
Courtesy of MAZDA MOTORS CORP.
REAR SASH MOLDING INSTALLATION
1. When installing a new rear sash molding, follow the procedure below:
1. Remove the adhesive remaining on the body using razor.
2. Remove any grease or dirt from the adhesion surface of the body.
2. When reusing the rear sash molding, follow the procedure below:
1. Remove the adhesive remaining on the rear sash molding and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the rear sash molding and the body.
3. Apply primer to the bonding area of the rear sash molding.
NOTE:
z
Double-sided adhesive tape has already been attached to the new rear
sash molding.
WARNING:
z
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
2008 Mazda CX-9 Grand Touring
2008 ACCESSORIES & BODY, CAB Exterior Trim - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:44:03 AM
Page 11
© 2005 Mitchell Repair Information Company, LLC.
