Mazda CX-9 Grand Touring 2008, Руководство пользователя

Страница: 2045 / 2589

9. Select "Ignition Key Code Erase" from the M-MDS screen menu and perform the procedure according to
the M-MDS screen.
10. Perform the card key programming. (See CARD KEY ID CODE REGISTRATION [ADVANCED
KEYLESS SYSTEM] .)
11. Perform the steering lock unit programming. (See STEERING LOCK UNIT ID CODE
REGISTRATION [ADVANCED KEYLESS SYSTEM] .)
12. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Exit (From
This Menu)" to finish the M-MDS procedure.
13. After Step 12, wait 5 s or more and then turn the ignition switch to the ON position.
14. Ignition switch to the LOCK position.
15. Disconnect the M-MDS from the DLC-2.
16. Using key 1, turn the ignition switch to the ON position.
17. After verifying that the security light and keyless warning light illuminate
for 3 s or more , turn the
ignition switch to the LOCK position and remove key 1.
18. Using key 2, turn the ignition switch to the ON position.
19. Verify that the security light and keyless warning light illuminate
for approx. 3 s , and then goes out.
20. After verifying that the security light goes out, turn the ignition switch to the LOCK position using key 2,
and then remove key 2.
21. If programming one more keys, repeat Steps 18 to 20 with a key to be programmed as key 3. If the
vehicle is left with the ignition switch in the ON position for 1 min or more, additional key programming
according to Steps 18 to 20 is disabled. If this occurs, refer to the " M-MDS CONNECTING
PROCEDURE " to program any additional keys. (See M-MDS MENU .)
22. Start the engine with key 1.
23. Verify that the security light and keyless warning light operate as follows:
z
From the point when the ignition switch is turned to the ON position, the security light illuminates
for approx. 3 s , and goes out.
z
The keyless warning light illuminates when the ignition switch is turned to the ON position, and the
light goes out after
approx. 1 s , and then displays the number of the programmed keys.
CAUTION:
z
The M-MDS displays "You must now program a minimum of two
keys.", however, do not perform the key programming and
proceed to Step 9. If the procedure is not followed, the engine
may not be started. The key programming procedure is
performed at Steps 16 to 21.
NOTE:
z
Although the security light remains illuminated and DTC 21 is
displayed after approx. 1 min, this does not indicate an improper
procedure. Continue to perform the procedure as indicated.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:47:59 AM Page 75 © 2005 Mitchell Repair Information Company, LLC.