WINDSHIELD INSTALLATION
1. Remove the sealant along the perimeter of the glass using a cutting a razor. (When reusing the glass)
2. Clean and degrease an
approx. 50 mm {1.97 in}
wide strip along the perimeter of the windshield.
3. If the existing windshield is to be reinstalled, attach the dam along the ceramic voids.
4. Inspect the glass for cracks. If it is cracked, chamfer it using sandpaper.
Courtesy of MAZDA MOTORS CORP.
WARNING:
z
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
CAUTION:
z
If a door is opened or closed when all the window glass is closed, the
resulting change in air pressure could cause the sealant to crack
preventing the proper installation of the glass. Keep the door glass
opened until the windshield installation is completed.
z
On vehicles with the auto wiper system, when the ignition switch is
turned to the ON position after replacing the rain sensor with a new
one, the windshield condition is verified and the initial setting is
stored. Before installing a rain sensor, always remove water or dirt
from the windshield. Perform the initial setting again in the following
cases: (See RAIN SENSOR REINITIALIZATION SETTING )
{
The windshield is replaced and the rain sensor is reused.
{
The auto wiper system operates incorrectly.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Glass/Windows/Mirrors - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:36:16 AM
Page 25
© 2005 Mitchell Repair Information Company, LLC.
