FRONT SASH MOLDING INSTALLATION
1. When installing a new front sash molding, follow the procedure below:
1. Remove the adhesive remaining on the body using razor.
2. Remove any grease or dirt from the adhesion surface of the body.
2. When reusing the front sash molding, follow the procedure below:
1. Remove the adhesive remaining on the front sash molding and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the front sash molding and the body.
3. Apply primer to the bonding area of the front sash molding.
4. Affix double-sided adhesive tape A to the front sash molding as shown in the figure.
Fig. 32: Peeling Off Rear Sash Film
Courtesy of MAZDA MOTORS CORP.
NOTE:
z
Double-sided adhesive tape has already been attached to the new front
sash molding.
WARNING:
z
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
2008 Mazda CX-9 Grand Touring
2008 ACCESSORIES & BODY, CAB Exterior Trim - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:44:03 AM
Page 23
© 2005 Mitchell Repair Information Company, LLC.
