1. Support the rear trailing link using a jack.
2. Separate the rear drive shaft (rear axle side) from the wheel hub.
3. Remove the rear trailing link.
Fig. 41: Supporting Rear Trailing Link
Courtesy of MAZDA MOTORS CORP.
BRACKET INSTALLATION NOTE
1. Install the bracket so that its angle as opposed to the rear trailing link is as shown in the figure.
Fig. 42: Identifying Bracket Angle
Courtesy of MAZDA MOTORS CORP.
REAR CROSSMEMBER REMOVAL/INSTALLATION [2WD]
CAUTION:
z
Removing the trailing link is dangerous. The trailing link could
fall and cause serious injury or death. Verify that the jack
securely supports the trailing link.
CAUTION:
z
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the
harness if it is pulled by mistake. Before performing the following
procedures, remove the ABS wheel-speed sensor (axle side) and fix it
2008 Mazda CX-9 Grand Touring
2008 SUSPENSION Rear Suspension - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:24:02 AM
Page 27
© 2005 Mitchell Repair Information Company, LLC.
