Mazda CX-9 Grand Touring 2008, Руководство пользователя

Страница: 30 / 2589

2
z
Turn the ignition switch to the LOCK position.
z
Disconnect the negative battery cable and wait
for 1 min or more .
z
Remove the B-pillar lower trim (RH). (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION .)
z
Disconnect the passenger-side pre-tensioner
seat belt connector. (See FRONT SEAT BELT
REMOVAL/INSTALLATION .)
z
Is there any malfunction of the passenger-side
pre-tensioner seat belt connector?
(See AIR BAG SYSTEM SERVICE
CAUTIONS .)
No Go to the next step.
3
VERIFY WHETHER MALFUNCTION IS IN
PASSENGER-SIDE PRE-TENSIONER SEAT
BELT OR RELATED WIRING HARNESS
z
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm
resistance to passenger-side pre-tensioner seat
belt connector terminals A and B.
z
Set the resistance of the SST (Fuel and
thermometer checker) to the 2-ohm position.
z
Connect the negative battery cable.
z
Turn the ignition switch to the ON position.
z
Are DTCs B1049, B1881, B1882, B1883,
and/or B1886 indicated?
Yes Go to the next step.
No
Replace the passenger-side pre-
tensioner seat belt. (See FRONT
SEAT BELT
REMOVAL/INSTALLATION .)
INSPECT WIRING HARNESS BETWEEN
PASSENGER-SIDE PRE-TENSIONER SEAT
BELT AND SAS CONTROL MODULE
z
Turn the ignition switch to the LOCK position.
z
Disconnect the negative battery cable and wait
for
1 min or more.
z
Remove the column cover. (See COLUMN
COVER REMOVAL/INSTALLATION .)
z
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION .)
z
Remove the glove compartment. (See GLOVE
COMPARTMENT
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:46 AM Page 30 © 2005 Mitchell Repair Information Company, LLC.