DIAGNOSTIC PROCEDURE
DTC P0010 (MZI-3.7) DIAGNOSTIC PROCEDURE
STEP
INSPECTION
ACTION
1
VERIFY FREEZE FRAME DATA HAS
BEEN RECORDED
z
Has FREEZE FRAME DATA been
recorded?
Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair
order, then go to the next step.
2
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
z
Verify related Service Bulletins and/or
on-line repair information availability.
z
Is any related Service Bulletins
available?
Yes
Perform repair or diagnosis according to the
available Service Bulletins.
z
If the vehicle is not repaired, go to the
next step.
No
Go to the next step.
3
INSPECT OCV (RH) CONNECTOR
FOR POOR CONNECTION
z
Turn the ignition switch off.
z
Disconnect the OCV (RH) connector.
z
Inspect for poor connection (such as
damaged/pulled-out pins, corrosion).
z
Are there any malfunction?
Yes
Repair or replace suspected part, then go to Step
10.
No
Go to the next step.
4
INSPECT OCV (RH)
z
Inspect the OCV (RH).
(See
OIL CONTROL VALVE
(OCV) INSPECTION [MZI-3.7]
.)
z
Is there any malfunction?
Yes
Replace the OCV (RH), then go to Step 10. (See
OIL CONTROL VALVE (OCV)
REMOVAL/INSTALLATION [MZI-3.7]
.)
No
Go to the next step.
5
INSPECT OCV (RH) CIRCUIT FOR
OPEN CIRCUIT
z
Turn the ignition switch to the ON
position (Engine off).
z
Measure the voltage between the OCV
(RH) connector terminal A and body
ground.
z
Is the voltage
B+
?
Yes Go to the next step.
No
Repair or replace suspected part, then go to Step
10.
INSPECT OCV (RH) CIRCUIT FOR
SHORT TO POWER SUPPLY
2008 Mazda CX-9 Grand Touring
2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:08:34 AM
Page 29
© 2005 Mitchell Repair Information Company, LLC.
