DTC P061B [MZI-3.7]
DTC P061B (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DIAGNOSTIC PROCEDURE
DTC P061B (MZI-3.7) DIAGNOSTIC PROCEDURE
and/or on-line repair information
availability.
z
Is any related Service Bulletins
available?
step.
No
Perform PCM reprograming using the M-MDS,
then go to next step.
3
VERIFY TROUBLESHOOTING OF
DTC P0610 HAS BEEN COMPLETED
z
Verify that all disconnected
connectors are reconnected.
z
Turn the ignition switch to the ON
position (Engine off).
z
Clear the DTC from the PCM
memory using the M-MDS.
z
Perform the "KOEO and KOER self-
test". (See
KOEO/KOER SELF
TEST [MZI-3.7]
.)
z
Retrieve DTCs using the M-MDS.
z
Is the PENDING CODE for this DTC
present?
Yes
Replace the PCM, then go to the next step. (See
PCM REMOVAL/INSTALLATION [MZI-
3.7]
.)
No
Go to the next step.
4
VERIFY AFTER REPAIR
PROCEDURE
z
Perform the "After Repair
Procedure". (See
AFTER REPAIR
PROCEDURE [MZI-3.7]
.)
z
Are any DTCs present?
Yes
Go to the applicable DTC inspection. (See
DTC
TABLE [MZI-3.7]
.)
No
Troubleshooting completed.
DTC P061B
Internal control module torque calculation performance
DETECTION
CONDITION
z
Indicates that a calculation error occurred in the PCM.
POSSIBLE
CAUSE
z
Connector or terminal malfunction
NOTE:
z
This DTC is an informational DTC and may be set in combination
with a number of other DTCs which are causing the FMEM.
Diagnose other DTCs first.
2008 Mazda CX-9 Grand Touring
2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:08:39 AM
Page 274
© 2005 Mitchell Repair Information Company, LLC.
