1
HAS BEEN RECORDED
z
Has FREEZE FRAME DATA
been recorded?
No
Record FREEZE FRAME DATA on the repair order,
then go to the next step.
2
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
z
Verify related Service Bulletins
and/or on-line repair information
availability.
z
Is any related Service Bulletins
available?
Yes
Perform repair or diagnosis according to the available
Service Bulletins.
z
If the vehicle is not repaired, go to the next
step.
No
Go to the next step.
3
INSPECT VEHICLE OPERATION
z
Check for:
{
Water, ice, mud and snow
causing wheel slippage.
{
Excessive engine speed in
N (Neutral).
{
Check whether the vehicle
way driven at a high rate of
speed.
z
Was the vehicle driven under any
of the above conditions?
Yes Vehicle is normal. Then go to the next step.
No
Clear DTCs and refer to "
DIAGNOSTIC INDEX
"
if customer had any drive ability concerns. (See
QUICK DIAGNOSTIC CHART [MZI-3.7]
.)
4
VERIFY TROUBLESHOOTING OF
DTC P0297 HAS BEEN
COMPLETED
z
Verify that all disconnected
connectors are reconnected.
z
Turn the ignition switch to the
ON position (Engine off).
z
Clear the DTC from the PCM
memory using the M-MDS.
z
Start the engine and run it at idle.
z
Retrieve DTCs using the M-
MDS.
z
Is the PENDING CODE for this
DTC present?
Yes
Replace PCM, then go to the next step. (See
PCM
REMOVAL/INSTALLATION [MZI-3.7]
.)
No
Go to the next step.
5
VERIFY AFTER REPAIR
PROCEDURE
z
Perform "AFTER REPAIR
PROCEDURE". (See
AFTER
Yes
Go to the applicable DTC inspection. (See
DTC
TABLE [MZI-3.7]
.)
2008 Mazda CX-9 Grand Touring
2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:08:36 AM
Page 150
© 2005 Mitchell Repair Information Company, LLC.
