z
If there is continuity, the circuit is shorted. Repair or replace the harness.
{
HO2S (RH) terminal A and power supply
{
HO2S (RH) terminal A and body ground
{
HO2S (RH) terminal B and power supply
{
HO2S (RH) terminal B and body ground
{
HO2S (RH) terminal C and body ground
{
HO2S (RH) terminal D and power supply
{
HO2S (LH) terminal A and power supply
{
HO2S (LH) terminal A and body ground
{
HO2S (LH) terminal B and power supply
{
HO2S (LH) terminal B and body ground
{
HO2S (LH) terminal C and body ground
{
HO2S (LH) terminal D and power supply
KNOCK SENSOR (KS) REMOVAL/INSTALLATION [MZI-3.7]
1. Disconnect the negative battery cable.
2. Remove the following part for easier access. Perform the following procedure to remove the intake
manifold
1. Remove the ventilation hose. (See
QUICK RELEASE CONNECTOR (EMISSION SYSTEM)
REMOVAL/INSTALLATION [MZI-3.7]
.)
2. Remove the vacuum hose (to purge solenoid valve). (See
QUICK RELEASE CONNECTOR
(EMISSION SYSTEM) REMOVAL/INSTALLATION [MZI-3.7]
.)
3. Remove the fuel hose. (See
QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION
[MZI-3.7]
.)
4. Remove the fuel distributor. (See
FUEL INJECTOR REMOVAL/INSTALLATION [MZI-
3.7]
.)
5. Remove the intake manifold. (See
INTAKE-AIR SYSTEM REMOVAL/INSTALLATION
[MZI-3.7]
.)
NOTE:
z
Put a tray under the converter housing to receive the engine coolant.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Control System (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:07:19 AM
Page 38
© 2005 Mitchell Repair Information Company, LLC.
