Fig. 30: Identifying License Plate Light Bulb & Lens
Courtesy of MAZDA MOTORS CORP.
3. Install in the reverse order of removal.
LENS REMOVAL NOTE
1. Insert a tape-wrapped flathead screwdriver into the service hole and pry with the screwdriver in the
direction shown by the arrow to remove the lens.
Fig. 31: Inserting Screwdriver Into Service Hole
Courtesy of MAZDA MOTORS CORP.
COMBINATION SWITCH REMOVAL/INSTALLATION
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the following parts:
1. Driver-side air bag module (See
DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION
.)
WARNING:
z
If the negative battery cable or the steering angle sensor connector
is disconnected, the stored initial position of the steering angle
sensor will be cleared and the DSC will not operate properly, making
the vehicle unsafe to drive. Perform the steering angle sensor
initialization procedure after connecting the negative battery cable.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Lighting Systems - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:39:06 AM
Page 20
© 2005 Mitchell Repair Information Company, LLC.
