Fig. 2: Identifying Wiring Harness Bracket, Starter, Connector & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
STARTER INSPECTION [MZI-3.7]
ON-VEHICLE INSPECTION
1. Verify that the battery is fully charged.
2. The starter is normal if it rotates smoothly and without any noise when the engine is cranked.
z
If the starter does not operate, inspect the following:
Remove the starter, and inspect the starter unit.
Inspect the related wiring harnesses, the ignition switch, and the transaxle range switch.
NO-LOAD TEST
1. Verify that the battery is fully charged.
2. Connect the starter, battery, and a tester as shown in the figure.
3. Operate the starter and verify that it rotates smoothly.
z
If the starter does not rotate smoothly, inspect the starter unit.
4. Measure the voltage and current while the starter is operating.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Starting System (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 9:56:47 AM
Page 2
© 2005 Mitchell Repair Information Company, LLC.
