2
INSPECT DRIVER-SIDE AIR BAG MODULE
CONNECTOR (CLOCK SPRING)
z
Turn the ignition switch to the LOCK position.
z
Disconnect the negative battery cable and wait
for
1 min or more.
z
Disconnect the driver-side air bag module
connector. (See
DRIVER-SIDE AIR BAG
MODULE REMOVAL/INSTALLATION
.)
z
Is there any malfunction of the driver-side air
bag module (inflator No.1) connector?
WARNING:
z
Handling the air bag system components
improperly can accidentally deploy the air
bag modules and pre-tensioner seat belts,
which may seriously injure you. Read the
service warnings and cautions before
handling the air bag system components.
(See AIR BAG SYSTEM SERVICE
WARNINGS .)
(See AIR BAG SYSTEM SERVICE
CAUTIONS .)
Yes
Replace the air bag wiring harness
and/or clock spring.
No
Go to the next step.
3
VERIFY WHETHER MALFUNCTION IS IN
DRIVER-SIDE AIR BAG MODULE OR
RELATED WIRING HARNESS
z
Connect the leads of the SST (Fuel and
thermometer checker) or apply 2-ohm resistance
to driver-side air bag module (inflator No.1)
connector terminals 3A and 3B, and driver-side
air bag module (inflator No.2) connector
terminals 4A and 4B.
z
Set the resistance of the SST (Fuel and
thermometer checker) to the 2-ohm position.
z
Connect the negative battery cable.
z
Turn the ignition switch to the ON position.
z
Are DTCs B1057, B1916, B1932, B1934 and/or
B1936?
Yes Go to the next step.
No
Replace the driver-side air bag
module.
(See
DRIVER-SIDE AIR BAG
MODULE
REMOVAL/INSTALLATION
.)
INSPECT CLOCK SPRING
z
Inspect the clock spring.
Yes Go to the next step.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:46 AM
Page 52
© 2005 Mitchell Repair Information Company, LLC.
