Mazda CX-9 Grand Touring 2008, Руководство пользователя

Страница: 40 / 2589

DTC B1054, B1877, B1878, B1879, B1885
2
z
Disconnect the driver and passenger-side curtain
air bag module connectors. (See CURTAIN
AIR BAG MODULE
REMOVAL/INSTALLATION
.)
z
Remove the B-pillar lower trim. (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION
.)
z
Disconnect the driver and passenger-side pre-
tensioner seat belt connectors. (See FRONT
SEAT BELT
REMOVAL/INSTALLATION .)
z
Disconnect the SAS control module connectors.
(See
SAS CONTROL MODULE
REMOVAL/INSTALLATION .)
z
Inspect the wiring harnesses between SAS
control module terminal 1W and crash zone
sensor terminal A, SAS control module terminal
1S and crash zone sensor terminal B for the
following:
{
Short to ground
{
Short to power supply
{
Open circuit
z
Is the wiring harness normal?
No Replace the air bag wiring harness.
3
INSPECT SAS CONTROL MODULE
z
Connect the SAS control module connector.
z
Connect the driver and passenger-side pre-
tensioner seat belt connectors.
z
Connect the driver and passenger-side curtain
air bag module connectors.
z
Connect the driver and passenger-side front seat
connectors.
z
Connect the passenger-side air bag module
connector.
z
Connect the clock spring connector.
z
Connect the crash zone sensor connector.
z
Connect the negative battery cable.
z
Turn the ignition switch to the ON position.
z
Is DTC B104D, B2226, B2227 and/or B2855
indicated?
Yes
Replace the SAS control module. (See
SAS CONTROL MODULE
REMOVAL/INSTALLATION
.)
No DTC troubleshooting completed.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:18:46 AM Page 40 © 2005 Mitchell Repair Information Company, LLC.