Fig. 37: Identifying Activation Switch
Courtesy of MAZDA MOTORS CORP.
9. Disconnect the
SSTs (Deployment tool)
form the
SSTs (Adapter harness)
.
SIDE AIR BAG MODULE
1. Disconnect the front seat connector.
2. Connect the
SST (Adapter harness)
to the side air bag module and pre-tensioner seat belt connector as
shown in the figure.
Fig. 38: Connecting SST To Side Air Bag Module And Pre-Tensioner Seat Belt Connector
Courtesy of MAZDA MOTORS CORP.
3. Connect the
SST (Deployment tool)
to the
SST (Adapter harness)
.
4. Connect the
SST (Deployment tool)
to the battery. Connect the power supply red clip to the positive
battery terminal, and the black clip to the negative battery terminal.
5. Verify that the red lamp on the
SST (Deployment tool)
is illuminated.
6. Verify that all persons are standing
at least 6 m {20 ft}
away from the vehicle.
WARNING:
z
Verify that air bag module operation (explosive) sound occurs
twice. If no operation (explosive) sound was heard or a single
operation (explosive) sound was heard, both inflators would
not have operated (deployed) properly. This may cause serious
injury if the air bag module operates (deploy) unexpectedly. If
the two operation (explosive) sounds are not heard, perform
Step 8 again. If a total of two operation (explosive) sounds
cannot be verified even though Step 8 is performed again,
leave the air bag module alone for 30 min or more before
approaching it again.
z
The air bag module is very hot immediately after it is operated
(deployed). You can be burned. Do not touch the air bag
module for at least 15 min after deployment.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:16:38 AM
Page 30
© 2005 Mitchell Repair Information Company, LLC.
