recorded?
order, then go to the next step.
2
VERIFY RELATED REPAIR
INFORMATION AVAILABILITY
z
Verify related Service Bulletins and/or
on-line repair information availability.
z
Is any related Service Bulletins
available?
Yes
Perform repair or diagnosis according to the
available Service Bulletins.
z
If the vehicle is not repaired, go to the
next step.
No
Go to the next step.
3
INSPECT DRIVE BELT CONDITION
z
Verify that drive belt auto tensioner
indicator mark does not exceed limit.
z
Is drive belt normal?
Yes Go to the next step.
No
Replace and/or adjust drive belt, then go to Step
12. (See
DRIVE BELT INSPECTION [MZI-
3.7]
.)
4
INSPECT GENERATOR TERMINAL
FOR POOR INSTALLATION
z
Turn the engine switch off.
z
Inspect generator terminal B for
looseness.
z
Are there any malfunction?
Yes
Connect generator terminal B correctly, then go
to Step 12.
No
Go to the next step.
5
INSPECT GENERATOR CIRCUIT FOR
SHORT TO POWER SUPPLY
z
Turn the ignition switch to the ON
position (Engine off).
z
Measure voltage between generator
terminal LI (wiring harness-side) and
body ground.
z
Is voltage
B+?
Yes
Repair or replace suspected part, then go to Step
12.
No
Go to the next step.
6
INSPECT GENERATOR CIRCUIT FOR
SHORT TO GROUND
z
Inspect for continuity between
generator terminal LI (wiring harness-
side) and body ground.
z
Is there continuity?
Yes Repair or replace suspected part, then go to the
next step.
No
Go to the next step.
7
INSPECT PCM CONNECTOR FOR
POOR CONNECTION
z
Turn the engine switch off.
z
Inspect for poor connection (such as
damaged/pulled-out terminals,
corrosion).
z
Are there any malfunction?
Yes
Repair or replace suspected part, then go to Step
12.
No
Go to the next step.
2008 Mazda CX-9 Grand Touring
2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
Microsoft
Sunday, November 15, 2009 10:08:39 AM
Page 282
© 2005 Mitchell Repair Information Company, LLC.
