Avaya Definity SI, Руководство по обслуживанию, Страница: 947 / 2968

ANN-PT (Announcement Port)
Issue 4 May 2002 10-161 555-233-123
number, the more severe the problem with that port. If this test fails,
announcements played over this port should sound corrupted.
Table 10-53. TEST #206 Playback Speech Memory Array (PSMA) Test
Error
Code Test
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available.
The port may be in use on a valid call.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort and the pack is not in use,
escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
“TDM-BUS (TDM Bus)” Maintenance documentation to
diagnose any active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling
heavy traffic, repeat the test at 1-minute intervals a
maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present or some Tone Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to “TTR-LEV (TTR Level)” Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to “TONE-PT (Tone Generator)” Maintenance
documentation.
3. If neither condition exists, retry the test at 1-minute
intervals a maximum of 5 times.
1024 ABORT Announcement circuit pack blocked the test because an
announcement download is in progress. If an announcement
download is in progress, a status data-module
<announcement data extension> command should show
that the announcement data port is connected to a NETCON
data channel, and the tape drive should be active. (To
determine the extension of the announcement data module,
use the list data-module command.)
See Note (a) at end of table for more information.
1. Wait until download is finished (could take a maximum of
45 minutes), and then run the test again.
2. If the test continues to abort and there is no download in
progress, escalate the problem.
Continued on next page