Avaya Definity SI, Руководство по обслуживанию, Страница: 1242 / 2968

Maintenance Object Repair Procedures
555-233-123 10-456 Issue 4 May 2002
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
TDM-BUS Maintenance to diagnose any active TDM-BUS
errors.
1. If system has no TDM-BUS errors and is not handling
heavy traffic, repeat test at 1-minute intervals a maximum
of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized force.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to TTR-LEV Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer
to TONE-PT Maintenance documentation.
3. If neither condition exists, retry the command at 1-minute
intervals a maximum of 5 times.
1004 ABORT System resources required to run this test are not available.
The port may be busy with a valid call. Use the display port
PCSSpp command to determine the trunk group/member
number of the port. Use the status trunk command to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for
certain tests. You must wait until the port is idle before
retesting.
1. If the port status is idle, retry the command at 1 minute
intervals for a maximum of 5 times.
1018 ABORT The test was disabled via administration. Verify that the
’Maintenance Test’ field on the ’Trunk Group’ form is set to ’n’.
To enable the test, issue the ’change trunk-group x’ command
(x equals the number of the trunk group to be tested). Then,
change the entry in the ’Maintenance Test’ field on the form to
’y’.
1. Retry the command at 1 minute intervals a maximum of 5
times.
2000 ABORT Response to the test was not received within the allowable
time period.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Table 10-168. TEST #33 Loop Around and Conference Circuit Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page