Avaya Definity SI, Руководство по обслуживанию, Страница: 2661 / 2968

UDS1-BD (UDS1 Interface Circuit Pack)
Issue 4 May 2002 10-1875 555-233-123
Table 10-674. TEST #139 Blue Alarm Inquiry Test
Error
Code Test
Result Description/Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals for a maximum of
5 times.
2000 ABORT Response to the test was not received within the allowable time
period. This may be due to hyperactivity. Error Type 1538 in the
error log indicates hyperactivity. The hyperactive circuit pack is
out of service and one or more of the following symptoms may
be exhibited.
1. The UDS1-BD tests (such as Test #138 and Test #139) are
aborting with error code 2000.
2. The tests run on the ports of this circuit pack are returning
a no board result.
3. A busyout or a release has no affect on the test results.
4. A list config shows that the circuit pack and the ports are
properly installed.
When hyperactivity occurs, the circuit pack is isolated from the
system, and all of the trunks for this circuit pack are placed into
the out of service state. The system will try to restore the circuit
pack within 15 minutes. When no faults are detected for 15
minutes, the UDS1 interface circuit pack is restored to normal
operation. All of the trunks for the UDS1 interface circuit pack
are then returned to the in service state. Hyperactivity is often
caused by the associated facility. In such a case, faults (such
as slips, misframes, or blue alarms) would be entered in the
error log. In addition, many hardware errors would be logged
against the associated trunk circuits. If the facility is OK and the
error occurs again after 15 minutes, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals for a maximum of
5 times.
Continued on next page