Avaya Definity SI, Руководство по обслуживанию, Страница: 843 / 2968

ANL-24-L (24-Port Analog Line)
Issue 4 May 2002 10-57 555-233-123
Station Present Test (also called Ringing
Application Test) (#48)
This test applies momentary ringing voltage to the terminal equipment and
monitors resulting current flow to determine whether terminal equipment is
connected to the port. This test may cause some terminal equipment to ring briefly
during daily maintenance. If this ringing disturbs the customer or the terminal
equipment, you can disable it via the Tests field on the change station form.
However, on some software releases, Tests #6, 7, 161, and 35 are disabled.
Table 10-22. TEST #48 Station Present Test
Error
Code Test
Result
Description/Recommendation
ABORT Could not allocate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1000 ABORT System resources required to run this test are not available.
The port may be busy with a valid call.
1004 ABORT The port was seized by a valid call during the test. The test
has been aborted.
1. Use the display port PCSSpp command to determine
the station extension.
2. Use the status station command to determine the
service state of the port.
3. If the port is in use, wait until the port is idle and retry the
command at 1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test
may not be applicable or it may be disruptive to terminal
equipment other than a voice terminal (for example, the
modem pool member or Music On Hold).
1008 ABORT Could not allocate a ringing circuit. Either all the ringing
circuits are in use or the ringing generator is defective or it is
not wired correctly.
1. Retry the command at 1-minute intervals a maximum of 5
times.
2. If the test continues to abort, look for RING-GEN errors in
the Error Log. If an ABORT 1008 occurs for this test on
other circuit packs as well, then the ringing generator may
be defective or is not wired correctly (see errors for
RING-GEN). If it does not occur on other ports, then all
four ring phases are in use.
Continued on next page