Avaya Definity SI, Руководство по обслуживанию, Страница: 929 / 2968

ANN-BD (Announcement Circuit Pack)
Issue 4 May 2002 10-143 555-233-123
1024 ABORT This abort code is given for the following reasons:
1. An announcement upload or download is in progress.
2. An announcement upload or download is requested when
this test is running.
3. A record is in progress.
4. A record request comes in when this test is running.
If an announcement upload or download is in progress, a
status data-module <announcement data extension>
command should show that the announcement data port is
connected to a NETCON data channel, and [for G3iV1.1-286]
the tape drive should be active or [for G3sV2, G3iV2-386, or
G3vsV2] the “card-in-use” amber LED for the memory card is
on (to determine the extension of the announcement data
module, use the list data-module command).
See Note (a) at end of table for more information.
1. Wait until the blocking event is finished, and then run this
test again. An upload or download could take up to 45
minutes to complete, and a recording session is finished
as soon as the station that was making the recording is
placed on-hook.
2. If the test continues to abort, and a record or
upload/download is not in progress, escalate the problem.
2000 ABORT Response to the test request was not received within the
allowable time period. If Error Type 1538 is present in the
Error Log, follow the maintenance strategy recommended for
this Error Type.
2100 ABORT Could not allocate the necessary system resources to run this
test.
ABORT Internal System Error.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Table 10-47. TEST #209 Announcement Checksum Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page