Avaya Definity SI, Руководство по обслуживанию, Страница: 1336 / 2968

Maintenance Object Repair Procedures
555-233-123 10-550 Issue 4 May 2002
2100 ABORT Could not allocate the necessary system resources to run the
test.
FAIL Internal System Error.
1. Retry the command at 1-minute intervals a maximum of 5
times.
PASS This test passed. Translation information was successfully
updated on the circuit pack.
1. If signaling troubles are reported (Error Types 1, 257, or
513 in Error Log table), verify translation information for
this port.
2. Refer problem to the CO. If the trunk is busied out, the test
does not run, but returns PASS.
To verify that the trunk is in-service:
1. Enter status-command to verify that the trunk is
in-service. If the trunk is in-service, no further action is
necessary. If the trunk is out-of-service, continue to Step
2.
2. Enter release-trunk command to put trunk back into
in-service.
3. Retry the test command.
0 NO
BOARD The test could not relate the internal ID to the port (no board).
1. Check to ensure that the board translations are correct.
Translate the board, if necessary.
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board command. This should re-establish
the linkage between the internal ID and the port.
Table 10-200. TEST #36 Port Audit Update Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page