Avaya Definity SI, Руководство по обслуживанию, Страница: 2501 / 2968

TDM-BUS (TDM Bus)
Issue 4 May 2002 10-1715 555-233-123
TDM Bus Clock Slip Inquiry Test (#149)
This test evaluates the quality of the synchronization source for the Tone-Clock
circuit pack. This test does not apply to the TN2182.
Table 10-630. TEST #149 TDM Bus Clock Slip Inquiry Test
Error
Code Test
Result Description/Recommendation
ABORT The system could not allocate the necessary resources for
the test.
1001 ABORT The system could not allocate the necessary resources for
the test.
1. Wait 1 minute, and retry the test.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
ANY FAIL This error represents the number of timing slips detected on
the incoming synchronization source since the last slip inquiry
was sent to the Tone-Clock circuit pack. The incoming
synchronization source can be from one of three sources: (1)
a DS1 Interface circuit pack, (2) an EXP-INTF circuit pack if
the port network on which the test was executed does not
contain the current system synchronization reference; (3) a
local oscillator on an Active Tone-Clock circuit pack. The error
code is a variable amount ranging from 1 to 255.
1. If there are errors against synchronization (SYNC), refer
to the Synchronization Maintenance documentation to
change the system synchronization reference.
2. If there are errors against DS1 Interface circuit pack
(DS1-BD), refer to the DS1 Interface circuit pack
Maintenance documentation to resolve the errors.
Continued on next page