Avaya Definity SI, Руководство по обслуживанию, Страница: 834 / 2968

Maintenance Object Repair Procedures
555-233-123 10-48 Issue 4 May 2002
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of tone detectors
present or some tone detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer
to “TTR-LEV”.
2. Look for TONE-PT errors in the Error Log. If present, refer
to “TONE-PT”.
3. Retry the command at 1-minute intervals a maximum of 5
times.
1004 ABORT The port was seized by a valid call during the test. The test
has been aborted. Use the display port PCSSpp command
to determine the station extension. Use the status station
command to determine the service state of the port. If the port
is in use, wait until the port is idle before testing.
1. Retry the command at 1-minute intervals a maximum of 5
times.
1005 ABORT The test was aborted due to a configuration problem. This test
may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the
modem pool member or Music On Hold).
1018 ABORT The test has been disabled by administration. The default for
the
Test
field on the station form is y. Determine why this field
has been set to
n
on this station (this may be due to the
ringing application test 48, that can be customer or terminal
disturbing).
1. To enable the test for a particular station being tested,
enter change station extension and set the
Test?
field
on the station from
n
to y.
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT System resources required to run test are not available. This
could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Table 10-18. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test
Result
Description/Recommendation
Continued on next page