Avaya Definity SI, Руководство по обслуживанию, Страница: 1245 / 2968

CO-TRK (CO Trunk)
Issue 4 May 2002 10-459 555-233-123
1006 ABORT The port has been placed out of service, perhaps by craft
busyout. Use the display port PCSSpp command to
determine the trunk group/member number of the port. Use the
status trunk command to determine the service state of the
port. If the service state indicates that the port is in use, then
the port is unavailable for certain tests. You must wait until the
port is idle before retesting.
1. If the port status is idle, retry the command at 1 minute
intervals for a maximum of 5 times.
2100 ABORT System resources required to run this test were not available.
1. If the port status is idle, retry the command at 1 minute
intervals for a maximum of 5 times.
FAIL Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5
times.
PASS This test passed. Translation information was successfully
updated on the circuit pack. User-reported troubles on this port
should be investigated by using other port tests and by
examining trunk or external wiring. If the trunk is busied out,
the test does not run, but returns PASS. To verify that the trunk
is in-service:
1. Enter status-command to verify that the trunk is
in-service. If the trunk is in-service, no further action is
necessary. If the trunk is out-of-service, continue to Step 2.
2. Enter release-trunk command to put trunk back into
in-service.
3. Retry the test command.
0 NO
BOARD The test could not relate the internal ID to the port (no board).
1. Check to ensure that the board translations are correct.
Translate the board, if necessary.
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board command. This should re-establish
the linkage between the internal ID and the port.
Table 10-169. TEST #36 Port Audit Update Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page