Avaya Definity SI, Руководство по обслуживанию, Страница: 824 / 2968

Maintenance Object Repair Procedures
555-233-123 10-38 Issue 4 May 2002
1004 ABORT The port was seized by a valid call during the test. The test
has been aborted.
1. Use the display port PCSSpp command to determine the
station extension.
2. Use the status station command to determine the
service state of the port. If the port is in use, it is
unavailable for certain tests. Wait until the port is idle
before testing.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
1005 ABORT This condition indicates that the test is not applicable when the
analog port is used in a combined modem pool. This error can
be ignored.
1018 ABORT Test disabled via administration.
1. To enable the test for the particular analog station being
tested, enter the change station <extension> command
and change the “Test?” field on the Station Form from “n”
to “y.”
2000 ABORT Response to the test request was not received within the
allowable time period.
2012 ABORT System could not respond to this request.
2100 ABORT Could not allocate the necessary system resources for this
test.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Any FAIL The NPE of the tested port was found to be transmitting in
error. This causes noisy and unreliable connections.
1. Replace the circuit pack.
PASS The port is correctly using its allocated time slots.
User-reported troubles on this port should be investigated by
using other port tests, by examining station wiring, or by
examining the station.
Table 10-14. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page