Avaya Definity SI, Руководство по обслуживанию, Страница: 1959 / 2968

OPS-LINE (DS1 OPS Line)
Issue 4 May 2002 10-1173 555-233-123
1004 ABORT The port has been seized by a user for a valid call. Use
status station or status trunk command to determine
when the port is available for testing.
1. Retry the command at one-minute intervals a
maximum of 5 times.
2. If the test continues to abort, and the port is not in use,
escalate the problem.
1018 ABORT The test was disabled via translation.
1. You may want to determine why the test has been
disabled before you enable it.
2. To enable the test for the particular analog station
being tested, enter the ’change station extension’
command, and then change the ’Test’ field on the
’Station’ form from ’n’ to ’y.’
1020 ABORT The test did not run due to an already existing error on the
specific port or due to a more general error on the circuit
pack.
1. Examine the error log for existing errors against this
port or the circuit pack and attempt to diagnose the
already existing error. (Error code 1793 indicates a
problem with the DS1 interface board, and any
problems on the associated DS1-BD or UDS1-BD
should be resolved first.)
2000 ABORT The test was aborted because response to the test was not
received within the allowable time period.
1. Retry the command at 1-minute intervals for a
maximum of 5 times.
2. If the test aborts with error code 2000 again, run short
test sequence on the associated DS1-BD or
UDS1-BD. If tests 138 through 145 on the associated
DS1-BD or UDS1-BD are also aborting with error code
2000, hyperactivity on the board or facility is indicated.
In this case, the hyperactivity problem should be dealt
with first.
2100 ABORT System resources required for this test are not available.
1. Retry the command at one-minute intervals a
maximum of 5 times.
Table 10-442. TEST #7 Conference Circuit Test — Continued
Error
Code Test
Result Description/Recommendation
Continued on next page